1.0.1 This standard specifies the technology methods, technical requirements, operating (construction) procedures and inspection criteria for stator assembly in site of hydro-generators with the unit capacity of 15MW or above, is applicable to the stator frame assembling and welding, iron core integral-stacking and all winding inserting with regards to stator assembly in power station of hydro-generators. This standard is not applicable to the site assembly of split stator or stator assembly carried out in the manufacturer of generator sets, with stators transported integrally to the site.
1.0.2 Hydro-generator stator in this standard refers to the common all air-cooling hydro-generator stator, internal cooling hydro-generator stator, flow-bulb hydro-generator stator and reversible generator-motor stator at the pumped storage power station.
1.0.3 Technology requirements for the stator assembly in site of hydro-generator with unit capacity less than 15MW may refer to relevant requirements in this standard.
2 Normative References
The following documents contain provisions which, through reference in this standard, constitute provisions of this standard. For dated references, subsequent amendments to (excluding correction to), or revisions of, any of these publications do not apply. However, parties coming to an agreement according to this standard are encouraged to research whether the latest editions of the documents below apply. For undated references, the latest edition of the normative document is applicable to this standard.
GB/T 8564 "Specification Installation of Hydraulic Turbine Generator Units"
GB/T 20835 "Guides for Magnetization Test of Generator Stator Core"
JB/T 8660 "Code for Packaging, Transport and Storage of Hydropower Units"
