GB 16895.26-2005 Electrical installations of buildings—Part 7-740:Requirements for special installations or locations—Structures,amusement devices and booths at fairgrouds,amusement parks and circuses
Electrical installations of buildings—Part 7-740:Requirements for special installations or locations—Structures,amusement devices and booths at fairgrouds,amusement parks and circuses
740.1.1 Scope
This Part specifies the minimum electrical installation requirements to facilitate the safe design, installation and operation of mobile, temporarily or permanently installed electrical machines and structures which incorporate electrical installations. The electrical machines and structures are intended to be installed repeatedly, without loss of safety, temporarily or permanently, at fairgrounds, circuses or any other places.
The object of this Part is to define the electrical installation requirements for such structures and machines, both being either integral parts or constituting the total amusement device.
This part does not apply to the electrical equipment of machines (see IEC 60204-1).
740.1.2 Normative References
The following normative documents contain provisions which, through reference in this text, constitute provisions of this Part. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this Part are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies.
GB 14048.2-2001 Low-voltage Switchgear and Controlgear - Low-voltage Circuit Breakers (idt IEC 60947-2: 1996)
GB 16895.3-2004 Electrical Installations of Buildings - Part 5-54: Selection and Erection of Electrical Equipment - Earthing Arrangements, Protective Conductors and Protective Bonding Conductors (IEC 60364-5-54: 2002, IDT)
GB 16895.21-2004 Electrical Installations of Buildings - Part 4-41: Protection for Safety - Protection Against Electric Shock (IEC 60364-4-41: 2001, IDT)
GB 16916.1-2003 Residual Current Operated Circuit-breakers without Integral Overcurrent Protection for Household and Similar Uses (RCCB) - Part 1: General Rules (IEC 61008-1: 1996, MOD)
GB 16917.1-2003 Residual Current Operated Circuit-breakers without Integral Overcurrent Protection for Household and Similar Uses(RCCB) - Part 1: General Rules (idt IEC 61009-1: 1996, MOD)
GB/T 17651 (all the parts) Measurement of Smoke Density of Cables Burning under Defined Conditions (idt IEC 61034)
GB/T 18380.1-2001 Tests on Electric Cables under Fire Conditions - Part 1: Test on a Single Vertical Insulated Wire or Cable (idt IEC 60332-1: 1993)
IEC 60038: 1983 IEC Standard Voltages
IEC 60050(826): 1982 International Electrotechnical Vocabulary (IEV) C Part 826: Electrical Installations of Buildings
IEC 60204-1: 1997 Electrical Equipment of Machines - Part 1: General Requirements
IEC 60332-3: 1992 Tests on Electric Cables under Fire Conditions - Part 3: Test on Bunched Wires or Cable
IEC 60364-3: 1993 Electrical Installations of Buildings - Part 3: Assessment of General Characteristics
1EC 60364-4 481: 1993 Electrical Installations of Buildings - Part 4: Protection for Safety. Chapter 48: Choice of Protective Measures as a Function of External Influences C Section 481: Selection of Measures for Protection against Electric Shock in Relation to External Influences
IEC 61046: 1993 DC or AC Supplied Electronic Step-down Convertors for Filament Lamps
IEC 61558-2-6: 1997 Safety of Power Transformers, Power Supply Units and Similar - Part 2: Particular Requirements for Safety Isolating Transformers for General Use
IEC 62020: 1998 Electrical Accessories-Residual Current Monitors (RCM) for Household and Similar Uses (RCMs)
CENTC152 Non-permanent Structures and Equipment for Fairgrounds and Amusement Parks: Safety
