This Standard specifies the requirements, test methods, inspection rules and others for photometric characteristics of front position lamps, rear position lamps, stop lamps, direction indicators and rear registration plate lamps for motorcycles and mopeds.
This Standard is applicable to front position lamps, rear position lamps, stop lamps, direction indicators and rear registration plate lamps for motorcycles and mopeds.
In this Standard, the signalling lights/lamps above are also called as "devices".
2 Normative References
The following documents contain provisions which, through reference in this text, constitute provisions of this Standard. For dated reference, subsequent amendments to (excluding correction to), or revisions of, any of these publications do not apply. However, the parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the standards. For undated references, the latest editions of the normative documents are applicable to this Standard.
GB 4599 Motor Vehicle Headlamps Equipped with Filament Lamps
GB 4785 Prescription for Installation of The External Lighting and Light-signalling Devices for Motor Vehicles and Their Trailers
GB 15766.1 Filament Lamps for Road Vehicles - Dimensional, Electrical and Luminous Requirements (GB 15766.1-2000, idt IEC 60809: 1995)
GB 18100 Provisions for Installation of Lighting and Light-signalling Devices for Motorcycles
ECE R37 Uniform Provisions Concerning the Approval of Filament Lamps for Use in Approved Lamp Units of Power-driven Vehicles and of Their Trailers
3 Terms and Definitions
For the purposes of this Standard, the terms and definitions specified in GB 18100 apply.
