This Part of GB 19510 specifies general and safety requirements for miscellaneous electronic circuits with luminaires for use on a. c. supplies up to 1000 V at 50 Hz or 60 Hz and/or d. c. supplies up to 250 V. This part does not apply to circuits or devices for which specific GB standards are published.
NOTE: Examples of miscellaneous electronic circuits used with luminaires are
- Electronic ballast control circuits;
- Switching circuits used in association with daylight and/or presence sensors;
- Circuits to assist EMC performance;
- Intermittence and similar devices used with lighting chains;
- Earth leakage or open-circuit protective devices used with neon transformers
2 Normative references
The following normative documents contain provisions which, through reference in this text of GB 19510, constitute provisions of this standard. For dated references, subsequent amendments (excluding amending errors in the text) to, or revisions of, any of these publications do not apply. However, all parties coming to an agreement according to this standard are encouraged to study whether the latest editions of these documents are applicable. For undated references, the latest edition of the normative documents referred to applies.
For the purpose of this part of GB 19510.1, the normative references given in Clause 2 of GB 19510-1 which are mentioned in this standard apply.
GB 19510-1:2004, Lamp controller C Part 1: General and safety requirements
3 Definitions
GB 19510.12-2005 The following standards are cited：
