This Part deals with the safety of hand-held motor-operated or magnetically driven electric tools, the rated voltage of the tools being not more than 250 V for single-phase a.c. or d.c. tools, and 440 V for three-phase a.c. tools.
So far as is practicable, this Part deals with the common hazards presented by hand-held tools which are encountered by all persons in the normal use and reasonably foreseeable misuse of the tools.
Tools with an electric heating element are within the scope of this Part. They should also comply with relevant parts of GB 4706.
Requirements for motors not isolated from the supply, and having basic insulation not designed for the rated voltage of the tools, are given in Appendix B. Requirements for rechargeable battery-powered motor-operated or magnetically driven tools and the battery packs for such tools are given in Appendix K. Those for such tools that are also operated and/or charged directly from the mains or a non-isolated source are given in Appendix L.
Hand-held electric tools, hereinafter referred to as tools, which can be mounted on a support or working stand for use as fixed tools without any alteration of the tool itself, are within the scope of this Part. Requirements for such supports or working stands are given in Appendix M.
This Part does not apply to:
— Hand-held tools intended to be used in the presence of explosive atmosphere (dust, vapour or gas);
— Hand-held tools used for preparing and processing food;
— Hand-held tools for medical purposes (IEC 60601);
— Heating tools which are covered by GB 4706.41.
For hand-held tools intended to be used in vehicles or on board ships or aircraft, additional requirements may be necessary.
For hand-held tools intended to be used in tropical countries, special requirements may be necessary.
Note: Attention is drawn to the fact that in many countries, additional requirements are specified by the national health authorities, the national authorities responsible for the protection of labour, the national water supply authorities, etc.
2 Normative References
The following normative documents contain provisions which, through reference in this text, constitute provisions of this Part of GB 3883. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this Part are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies.
