This standard specifies specimen preparation, shear test, tensile test and test report of mechanical properties of ring of filament-winding reinforced plastics.
This standard is applicable to fabrication of ring of filament-winding reinforced plastics and determination of interlaminar shear strength, tensile strength and tensile modulus of elasticity for ring of filament-winding reinforced plastics, and tensile strength of filament.
2 Normative References
The following normative documents contain provisions which, through reference in this standard, constitute provisions of this standard. For dated reference, subsequent amendments (excluding corrections), or revisions, of any of these publications do not apply to this standard. However, parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies.
GB/T 1446 The Generals of Test Methods for Properties of Fiber-reinforced Plastics
GB/T 2577 Test Method for Resin Content of Glass Fiber Reinforced Plastics
GB/T 3855 Test Method for Resin Content of Carbon Fiber Reinforced Plastics
3 Method Summary
3.1 Specimen preparation method
3.1.1 General
Specimens are fabricated by single ring winding method or cylinder slit-ring method. In both methods, either wet winding or presoaking winding method applies. See Figures 1 and 2 for the two types of winding process respectively. For performance comparison, the same fabrication method shall be adopted.
