This part specifies a method for determining the ability of metallic wire of diameter 0.1mm to 14mm inclusive to undergo plastic deformation during reverse torsion in one direction. This test method is used for detecting surface and internal defects in wires.
2 Normative References
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
GB/T 239.1 Metallic Materials — Wire — Part 1: Simple Torsion Test (GB/T 239.1-2012, ISO 7800:2003, MOD)
3 Symbols and Designations
The symbols and designations used in the simple torsion test of wires are shown in Figure 1 and listed in Table 1.
GB/T 239.2-2012 The following standards are cited: