This Standard specifies tolerances, design features and test methods for thin-walled half bearings with integral flange up to an outside diameter of Do of 250 mm and without flange up to an outside diameter of Do of 500 mm. Due to the variety of design it is, however, not possible to standardize the dimensions of the half bearings.
Half bearings according to This Standard are predominantly used in reciprocating machinery and consist of a steel backing and one or more bearing metal layers on the inside.
In reciprocating machinery, flanged half bearings may be used in connection with half bearings without flange.
Alternatively to serve as a flanged half bearing, it is possible to use a half bearing without flange together with two separate half thrust washers in accordance with GB/T 10447; or a half bearing with assembled flanges.
2 Normative References
The following normative documents contain provisions which, through reference in this text, constitute provisions of this Standard. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this Part are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies.
