Steel Wire Ropes — Determination of Measured Breaking Force
1 Scope
This standard specifies terms and definitions, test principle, sample preparation, test equipment, test procedure and test report for the determination of measured breaking force of steel wire ropes.
This standard is applicable to the determination of measured breaking force of different kinds of steel wire rope products. The method of alloy poured socketing is applicable to steel wire ropes of diameter greater than or equal 6mm, or of wire rope diameter greater than or equal 0.5mm; the method of resin pouring and method of ferrule pressing are applicable to all kinds of steel wire ropes; the method of directly gripping is applicable to steel wire ropes in single-strand and other structures; the method of wrapping is applicable to steel wire ropes of diameter not greater than 20mm.
2 Normative References
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
GB/T 8706 Steel Wire Ropes — Vocabulary, Designation and Classification (GB/T 8706-2006, ISO 17893:2004, IDT)
GB/T 16825.1 Verification of Static Uniaxial Testing Machines — Part 1: Tension/Compression Testing Machines — Verification and Calibration of the Force-measuring System (GB/T 16825.1-2008, ISO 7500-1:2004, IDT)
3 Terms and Definitions
For the purpose of this document, the terms and definitions given in GB/T 8706 and the following apply.
