This standard specifies the technical requirements, inspection methods, inspection rules, and marking and packaging of magnetic particle flaw detectors (hereinafter referred to as "flaw detectors").
This standard is applicable to alternating current, direct current, half-wave rectified and full-wave rectified flaw detectors, but is not applicable to the yoke type magnetic particle flaw detectors.
2 Normative References
The following standards contain provisions which, through reference in this text, constitute provisions of this standard. For dated references, subsequent amendments to (excluding corrections to) or revisions of, any of these publications do not apply. However, parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below. For undated references, the latest edition of the normative document referred to applies.
GB/T 2611-2007 General Requirements for Testing Machines
GB/T 5097-2005 Non-destructive Testing - Penetrant Testing and Magnetic Particle Testing - Viewing Conditions (ISO 3509:2001, IDT)
GB/T 19001 Quality Management Systems - Requirements (GB/T 19001-2008, ISO 9001:2008, IDT)
GB/T 12604.5-2008 Non-destructive Testing - Terminology - Terms Used in Magnetic Particle Testing
JB/T 6147-2007 Requirements for the Packaging, Packaging Marking and Handling of Testing Machine Products
JB/T 7406.2-1994 Testing Machine Terminology - Non-destructive Test Instrument
3 Terminologies and Definitions
For the purposes of this standard, the terminologies and definitions established in GB/T 12604.5 and JB/T 7406.2 apply.