This standard specifies the types and basic parameters, requirements, test methods, inspection rules, marking, packaging, transportation and storage of shearer variable frequency adjustable speed definite purpose converter-fed YBVF series travel motors.
This standard is applicable to shearer variable frequency adjustable speed definite purpose converter-fed YBVF series travel motors (hereinafter referred to as motor). The other motors derived from this series of motors may also be made reference to this standard.
2 Normative References
The following standards contain provisions which, through reference in this standard, constitute provisions of this standard. For dated reference, subsequent amendments to (excluding corrections to), or revisions of, any of these publications do not apply. However, the parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the standards. For undated references, the latest edition of the normative document referred to applies.
GB/T 191 Packaging-Pictorial Marking for Handling of Goods (GB/T 191-2000, eqv ISO 780: 1997)
GB 755-2000 Rotating Electrical Machines-Rating and Performance (idt IEC 60034-1: 1996)
GB/T 997-2003 Classification of Types of Construction and Mounting Arrangements for Rotating Electrical Machines (IM Code) (IEC 60034-7: 1992, IDT)
GB/T 1032-2005 Test Procedure for Three-phase Induction Motors
GB/T 1993-1993 Cooling Methods for Rotating Electrical Machines (eqv IEC 60034-6: 1991)
GB/T 2423.4-1993 Basic Environmental Testing Procedures for Electric and Electronic Products - Test Db: Damp Heat, Cyclic (eqv IEC 68-2-30: 1980)
GB 3836.1-2000 Electrical Apparatus for Explosive Gas Atmospheres - Part 1: General Requirements (eqv IEC 60079-0: 1998)
GB 3836.2-2000 Electrical Apparatus for Explosive Gas Atmospheres - Part 2: Flameproof Enclosure d (eqv IEC 60079-1: 1990)
GB/T 4942.1-2006 Degrees of Protection Provided by the Integral Design of Rotating Electrical Machines (IP Code) - Classification (IEC 60034-5: 2000, IDT)
GB/T 10068-2000 Mechanical Vibration of Certain Machines with Shaft Heights 56 mm and Higher-Measurement, Evaluation and Limits of Vibration (idt IEC 60034-14: 1996)
GB/T 10069.1-2006 Measurement of Airborne Noise Emitted by Rotating Electrical Machines and the Noise Limits Part 1: Method for the Measurement of Airborne Noise Emitted by Rotating Electrical Machines (ISO 1608: 1999, MOD)
JB/T 9615.1- 2000 Test Methods of the Interturn Insulation on Random Wound Winding for AC Low-voltage Machines
MT 451-1995 General Specification for Low Voltage Three Phases Flameproof Induction Motor for Coal Mine
