This standard specifies the terms and definitions, classification, requirements, test methods, inspection rules, marking, instructions, packaging, transportation and storage of wooden furniture.
This standard is applicable to quality test and evaluation of wooden furniture, and may also serve as a reference for wooden parts of other furniture. If specific product standard is available, the requirements of product standards shall be met.
2 Normative references
The following normative documents contain provisions which, through reference in this text, constitute provisions of this standard. For dated references, subsequent amendments (excluding corrections), or revisions, of any of these publications do not apply to this standard. However parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition applies.
GB/T 1931 Method for determination of the moisture content of wood
GB/T 2828.1-2003 Sampling procedures for inspection by attributes - Part 1: Sampling schemes indexed by acceptance quality limit (AQL) for lot-by-lot inspection
GB/T 4893.1-2005 Furniture - Assessment of surface resistance to cold liquids
GB/T 4893.2-2005 Furniture - Assessment of surface resistance to wet heat
GB/T 4893.3-2005 Furniture - Assessment of surface resistance to dry heat
GB/T 4893.4 Furniture - Assessment of adhesion of surface coatings - Cross cut
GB/T 4893.7 Furniture - Assessment of surface resistance to alteration of heat and cold
GB/T 4893.8 Furniture - Assessment of wearability of surface coatings
GB/T 4893.9 Furniture - Test for surfaces - Assessment of resistance to impact
GB/T 4897.3-2003 Particle board - Part 3: Requirements for boards for interior fitments (including furniture) for use in dry conditions
QB/T 1951.1-2010 The following standards are cited：
