This standard specifies the terms and definitions, performance requirements, and bench test methods for plastic reservoir assembly of automobile hydraulic brake system.
This standard is applicable to plastic reservoir assembly of automobile hydraulic brake system. It may also be referred to for the plastic reservoir assembly for master cylinder of automobile clutch.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the normative document (including any amendments) applies.
GB 11121 Gasoline engine oils
GB 11122 Diesel engine oils
GB 17930 Gasoline for motor vehicles
GB 18351 Ethanol gasoline for motor vehicles (E10)
3 Terms and definitions
For the purpose of this standard, the following terms and definitions apply.
3.1
maximum level
the highest position of brake fluid allowed to fill in the reservoir assembly (see Figure 1)
