This standard specifies the terms and definitions, technical requirements, test methods, inspection rules, marking, packaging, transportation and storage of vehicle door outside handle.
This standard is applicable to the outside handle installed on M1 and N1 automobiles.
2 Normative references
The following referenced documents are indispensable for the application of this standard. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
GB/T 10125 Corrosion tests in artificial atmospheres - Salt spray tests
GB 11566-2009 External projections for passenger car
GB 20182-2006 The cab of commercial vehicles - External projections
QC/T 15-1992 General test method for automobile plastic products
QC/T 625-1999 Metallic coatings and conversion coatings for automobile
3 Terms and definitions
For the purpose of this standard, the following terms and definitions apply.
3.1
outside handle
component located at the outside of the vehicle door and used for opening the door, which is classified into lifting type outside handle and pulling type outside handle based on the type.
4 Technical requirements
4.1 General requirements
4.1.1 The outside handle shall be manufactured in accordance with the product drawings approved by the prescribed procedures and relevant technical documents, and shall meet the requirements of this standard.
4.1.2 The outside handle shall meet the relevant requirements of GB 11566-2009 or GB 20182-2006.
