This Part gives guidance and explanatory comments on the existing procedures for lightning and switching impulse testing of power transformers to supplement the requirements of GB 1094.3. It is also generally applicable to the testing of reactors (see GB/T 10229), modifications to power transformer procedures being indicated where required.
This Part gives the information on waveshapes, test circuits including test connections, earthing practices, failure detection methods, test procedures, measuring techniques and interpretation of results.
Where applicable, the test techniques specified in this Part are as recommended in GB/T 16927.1 and GB/T 16927.2.
2 Normative References
The following normative documents contain provisions which, through reference in this text, constitute provisions of this Part of GB 1094. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this Standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative documents referred to applies.
GB 1094.3 Power Transformers — Part 3: Insulation Levels, Dielectric Tests and External Clearances in Air (GB 1094.3-2003, IEC 60076-3:2000, MOD)
GB/T 10229 Reactors (GB/T 10229-1988, eqv IEC 60289:1987)
GB/T 16896.1 Digital Recorders for Measurements in High-voltage Impulse Tests C Part 1: Requirements for Digital Recorders (GB/T 16896.1-1997, eqv IEC 61083-1:1991)
GB/T 16927.1 High Voltage Test Techniques — Part 1: General Test Requirements (GB/T 16896.1-1997, eqv IEC 61083-1:1991)
GB/T 16927.2 High Voltage Test Techniques — Part 2: Measuring Systems (GB/T 16927.1-1997, eqv IEC 60060-1:1989)
IEC 61083-2 Digital Recorders for Measurements in High-voltage Impulse Tests — Part 2: Evaluation of Software Used for the Determination of the Parameters of Impulse Waveforms
GB/T 1094.4-2005 The following standards are cited:
GB/T 1094.4-2005 Cited by the following standards: