This standard specifies terms and definitions, classification, requirements, inspection method, inspection rules as well as marking, packaging, transport and storage of engineered wood flooring.
This standard is applicable to floor board with solid-wood jointed board or veneer (including reconstituted decorative veneer) as face-plate and solid-wood jointed board, veneer or plywood as core layer or bottom layer, which is produced through different combination, laminating and processing; this standard is applicable to indoor engineered wood flooring for general purposes.
2 Normative References
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
GB/T 2828.1-2012 Sampling Procedures for Inspection by Attributes - Part 1: Sampling Schemes Indexed by Acceptance Quality Limit (AQL) for Lot-by-lot Inspection
GB/T 4823-1995 Defects in Sawn Timber
GB/T 4893.4-1985 Furniture - Assessment of Adhesion of Surface Coatings - Cross Cut
GB/T 6739-2006 Paints and Varnishes - Determination of Film Hardness by Pencil Test
GB/T 15036.2-2009 Solid Wood Flooring - Part 2: Examination Methods
GB/T 17657-1999 Test Methods of Evaluating the Properties of Wood-based Panels and Surface Decorated Wood-based Panels
GB 18580 Indoor Decorating and Refurbishing Materials - Limit of Formaldehyde Emission of Wood-based Panels and Finishing Products
LY/T 1654-2006 Reconstituted Decorative Veneer
LY/T 1738 Plywood for Solid Wood Composite Flooring
3 Terms and Definitions
For the purposes of this document, the terms and definitions given in GB/T 4823-1995 and the following apply. For the convenience of application some terms and definitions in GB/T 4823-1995 are listed below.