GB/T 21437.2-2008 Road vehicles - Electrical disturbances from conduction and coupling - Part 2: Electrical transient conduction along supply lines only
This part specifies bench tests for testing the compatibility to conducted electrical transients of equipment installed on passenger cars and light commercial vehicles fitted with a 12 V electrical system or commercial vehicles fitted with a 24 V electrical system — for both injection and the measurement of transients. Failure mode severity classification for immunity to transients is also given in this part.
This part is applicable to these types of road vehicle, independent of the propulsion system (e.g. spark ignition or diesel engine, or electric motor).
2 Normative References
The following normative document contains provisions which, through reference in this text, constitute provisions of this part of GB/T 21437. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this part are encouraged to investigate the possibility of applying the most recent edition of the normative document indicated below. For undated references, the latest edition of the normative document referred to applies.
GB/T 21437.1 Road Vehicles — Electrical Disturbances from Conduction and Coupling — Part 1: Definitions and General Considerations (GB/T 21437.1-2008, ISO 7637-1:2002, IDT);
ISO 8854:1988 Road Vehicles — Alternators with Regulators — Test Methods and General Requirements
3 Terms and Definitions
For the purpose of this document, the terms and definitions given in GB/T 21437.1 apply.