This standard specifies the electromagnetic compatibility requirements and test methods of drive motor system for electric vehicles.
This standard is applicable to drive motor systems for battery electric vehicles, hybrid electric vehicles and fuel cell electric vehicles.
This standard considers the components of HV (high voltage) power supply system as a typical fully shielded system.
Note: There are usually two types of power supply systems for electric vehicles: the common LV (low voltage) system with a typical feature of unshielded structure, and the HV system with a typical feature of shielded structure.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
GB/T 18384.3-2015 Electrically propelled road vehicles - Safety specifications - Part 3: Protection of persons against electric shock
GB/T 18655-2010 Vehicles boats and internal combustion engines - Radio disturbance characteristics - Limits and methods of measurement for the protection of on-board receivers
GB/T 19951 Road vehicles - Test methods for electrical disturbances from electrostatic discharge
GB/T 21437.2-2008 Road vehicles - Electrical disturbances from conduction and coupling - Part 2: Electrical transient conduction along supply lines only
GB/T 29259 Road vehicle - Electromagnetic compatibility terminology
GB/T 33014.1 Road vehicles - Component test methods for electrical/electronic disturbances from narrowband radiated electromagnetic energy - Part 1: General
GB/T 33014.2 Road vehicles - Component test methods for electrical/electronic disturbances from narrowband radiated electromagnetic energy - Part 2: Absorber-lined shielded enclosure
GB/T 33014.4 Road vehicles - Component test methods for electrical/electronic disturbances from narrowband radiated electromagnetic energy - Part 4: Bulk current injection (BCI)
3 Terms and definitions
For the purposes of this document, the terms and definitions given in GB/T 29259 and the following apply.
3.1
equipment under test; EUT
specifically the drive motor system for electric vehicles in this standard
3.2
low voltage; LV
a voltage corresponding to the Class A voltage specified in GB/T 18384.3-2015
3.3
high voltage; HV
a voltage corresponding to the Class B voltage specified in GB/T 18384.3-2015
3.4
high voltage artificial network; HV AN
a device that is connected in series in the high voltage DC power line of the EUT, provides, in a given frequency range, a specified load impedance for the measurement of disturbance voltage and isolates the EUT from the power supply
GB/T 36282-2018 The following standards are cited: