1.1 Scope
This Part of GB/T 5013 gives the test methods specified in all parts of GB/T 5013 as far as not laid down in GB/T 2951.
1.2 Normative references
The following normative documents contain provisions which, through reference in this text, constitute provisions of this Part of GB/T 5013. At the time of publication, the editions indicated were valid. All normative documents are subject to revision and parties to agreements based on this Part are encouraged to investigate the possibility of applying the most recent editions of the normative documents listed below.
GB/T 131 Technical drawings — Method of indicating surface texture (GB/T 131-2006, ISO 1302:1992, IDT)
GB/T 2951.1-1997 Common test methods for insulating and sheathing materials of electric cables — Part 1: Methods for general application — Section 1: Measurement of thickness and overall dimensions — Tests for determining the mechanical properties (idt IEC 60811-1-1:1993)
GB/T 2951.2-1997 Common test methods for insulating and sheathing materials of electric cables — Part 1: Methods for general application — Section 2: Thermal ageing methods (idt IEC 60811-1-2:1985)
GB/T 5013.1-2008 Rubber insulated cables — Rated voltages up to and including 450/750 V — Part 1: General requirements (IEC 60245-1:2003, IDT)
GB/T 5013.3 Rubber insulated cables — Rated voltages up to and including 450/750 V — Part 3: Heat resistant silicone insulated cables (GB/T 5013.3-2008, IEC 60245-3:1994, IDT)
GB/T 5013.4-2008 Rubber insulated cables — Rated voltages up to and including 450/750 V — Part 4: Cords and flexible cables (IEC 60245-4:2004, IDT)
GB/T 5013.8-2006 Rubber insulated cables — Rated voltages up to and including 450/750 V — Part 8: Cords for applications requiring high flexibility (IEC 60245-8:1998, IDT)
GB/T 18380.1 Tests on electric cables under fire conditions — Part 1: Test on a single vertical insulated wire or cable (GB/T 18380.1-2001, IEC 60332-1:1993, IDT)
1.3 Classification of tests according to the frequency with which they are carried out
The tests specified are type tests (symbol T) and/or sample tests (symbol S) as defined in 2.2 of GB/T 5013.1-2008.
The symbols T and S are used in the relevant tables of the particular specifications (GB/T 5013.3, GB/T 5013.4, etc.).
1.4 Sampling
If a marking is in relief in insulation or sheath the samples used for the tests shall be taken so as to include such marking.
For multicore cables, except for the test specified in 1.9, not more than three cores (of different colours, if applicable) shall be tested unless otherwise specified.
1.5 Pre-conditioning
All the tests shall be carried out not less than 16 h after the vulcanization of the insulating or sheathing compounds.
1.6 Test temperature