This standard specifies a method for the determination of the tensile stress-strain properties of vulcanized and thermoplastic rubbers.
This standard is applicable to the determination of the properties of vulcanized and thermoplastic rubbers, like the tensile strength, elongation at break, stress at a given elongation, elongation at a given stress, tensile stress at yield point and elongation at yield point. The measurement of the tensile stress and strain at the yield point applies only to some thermoplastic rubbers and certain other compounds.
Note: If necessary, the determination of the breaking permanent deformation may also be added.
2 Normative References
The following standards contain provisions which, through reference in this text, constitute provisions of this standard. For dated reference, subsequent amendments to (excluding correction to), or revisions of, any of these publications do not apply. However, parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below. For undated references, the latest edition of the normative document referred to applies.
GB/T 2941 "Rubber--General Procedures for Preparing and Conditioning Test Pieces for Physical Test Methods" (GB/T 2941-2006, ISO 23529: 2004, IDT)
ISO 5893 "Rubber and Plastics Test Equipment--Tensile, Flexural and Compression Types (Constant Rate of Traverse)--Specification"