This Standard specifies boundary dimensions, tolerances, radial internal clearances and specifications for dimension series E, EH, G, GH and K of spherical plain bearing rod ends.
Spherical plain bearing rod ends don’t need to conform to the designs illustrated but compliance is required as regards dimensions, tolerances and radial internal clearances specified.
The dimensions and tolerances specified in this Standard have been selected to permit the design and use of spherical plain bearing rod ends which incorporate radial spherical plain bearings having various sliding material combinations. .(for manufactures’ production, inspection and customers’ acceptance)
This Standard is not apply to the spherical plain bearing rod ends for airframe applications and specific spherical plain baring rod ends for direct connection to hydraulic cylinders.
2 Normative References
The following standards contain provisions which, through reference in this text, constitute provisions of this Standard. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this Standard are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below.
GB/T 197-1981 General Purpose Screw Threads — Tolerances and Fits for Diameter from 1 to 355mm
GB/T 274-2000 Rolling Bearings — Chamfer Dimension — Maximum Values (idt ISO 582:1995)
GB/T 3944-1983 Spherical Plain Bearing Joint Type — Vocabulary (eqv ISO 6811:1983)
GB/T 4199-1984 Rolling Bearings — Tolerances — Definitions (idt ISO 1132:1980)
GB/T 9163-2001 Spherical Plain Bearings — Radial Spherical Plain Bearings
JB/T 8879-2001 Spherical Plain Bearings — General Specifications
