This Standard specifies performance requirements and test methods of TPM Sensor Module Based Tire Pressure Monitoring Systems for Motor Vehicles (TPMS).
This Standard is applicable to TPM Sensor Module based tire pressure monitoring systems for motor vehicles installed on Category M and N automobiles.
2 Normative References
The following referenced documents are indispensable for the application of this Standard . For dated references, only the edition cited applies. For undated references, the latest edition of the normative document (including any amendments) applies.
GB/T 2423.1 Environmental Testing for Electric and Electronic Products-Part 2: Test methods-Tests A: Cold
GB/T 2423.2 Environmental Testing for Electric and Electronic Products-Part 2: Test methods-Test B: High Temperature
GB/T 2423.17 Environmental Testing for Electric and Electronic Products-Part 2: Test Method-Test Ka: Salt Mist
GB/T 2423.22 Environmental Testing for Electric and Electronic Products-Part 2: Test Methods-Test N: Change of Temperature
GB/T 2423.34 Environmental Testing for Electric and Electronic Products-Part 2: Test Methods-Test Z/AD: Composite Temperature/Humidity Cyclic Test
GB 14023-2006 Vehicles Boats and Internal Combustion Engine Driven Devices Radio Disturbance Characteristics Limits and Methods of Measurement
GB/T 17619-1998 Limits and Methods of Testing for Immunity of Electrical/Electronic Sub-assemblies in Vehicles to Electromagnetic Radiation
GB 18655-2002 Limits and Methods of Measurement of Radio Disturbance Characteristics for the Protection of Receivers Used on Board Vehicles
GB/T 19951-2005 Road Vehicles-Test Methods for Electrical Disturbances from Electrostatic Discharge
GB/T 21437.2-2008 Road Vehicles-Electric Disturbance Caused by Conduction and Coupling - Part 2: Electric Transient Conduction along Powder Line
QC/T 413-2002 Basic Specification for Automotive Electrical Equipment
ISO 2575: 2004 Road Vehicle Controller, Indicator and Signal Device Symbol
ISO 16750-1 Road Vehicles-Environmental Conditions and Testing for Electrical and Electronic Equipment-Part 1: General Requirements
ISO 16750-3 Road Vehicles-Environmental Conditions and Testing for Electrical and Electronic Equipment - Part 3: Mechanical Load
ISO 20653: 2006 Road Vehicles-Degrees of Protection (IP Code)- Protection of Electrical Equipment against Foreign Objects, Water and Access
3 Terms and Definitions
For the purposes of this document, the following terms and definitions apply.
3.1
Tire pressure monitoring systems
TPMS
Auxiliary system that is attached to vehicles to conduct real-time monitor for tire pressure parameters and displays and give an alarm with visual signal (may also including audible signal) to raise vehicle traveling safety, and reduces the abrasion and vehicle energy consumption caused by insufficient or higher air pressure.
3.1.1
TPM sensor module
Component assembly attached to the inside of tire or surface of wheel to measure tire pressure parameters and conduct information transmission.
3.1.2
Receiver module
Components used to receive the information sent by tire pressure monitoring module and to send signal to display module.
Note: sometimes receiver module and display module are combined together.
3.1.3
Display module
Device used to display such information as graphic symbol, character or value of alarm instruction.
3.2
Recommended cold tyre inflation pressure
prec
Air pressure value recommended for tyres at each position by vehicle manufacturers aimed at the scheduled working conditions of designated vehicle.
GB/T 26149-2010 The following standards are cited：
